Technology has made it easier again...

Inorder to generate light with salt and water you need the following materials:

Salt,Water, flexible wires, a container and Light emmiting diode (LED).
After you might have gotten this tools we are good to go.

The first step goes like this

You cut the flexible wires into two equal halves.
Step two.
You'll take you led which has two tiny silver wire below in and connect the two flexible wires onto the two two silver wire of the led.

Step 3.
You get your container and fill it with water and also mix it with one teaspoonful of salt.

The last step:

You'll take your already connected flexible wires and LED and put the flexible wires into the salt water solution the you'll notice that the LED will on to increase the rate of brightness of the LED.



You can add a 9volt battery to your circuit i.e instead of putting the two flexible wires into the salt water you'll put one inside the salt water and the other on the positive terminal of the 9 volt battery then on the negative terminal of the 9 volt battery you'll connect a flexible wire to it and dip it inside the salt water.

Then the project is ready.

Feel free to like, share and follow up for more updates